Radlink CR Pro Guía de instalación descargar pdf (Pagina 10)

Hardware Installation

1. Place the CR-Pro on a solid flat, leveled surface.

2. Plug the power cord to the AC Power Adapter located on the back of the

CR-Pro. (Figure 1)

3. Plug the end of the power cord to an available power outlet. A UPS/Line

conditioner is recommended. It is desirable to have the CR-Pro on an

isolated circuit to avoid conducted noise from other devices affecting the

quality of operation.

4. Plug one end of the Ethernet cable (Cat5/6) into the CR-Pro Ethernet port

(see Figure 1). Note: Do not route the Ethernet cable and the power cable

in close proximity as power cable radiation may affect transmission of

data.

6. Turn the Power ON/OFF switch on the back of the CR Pro to ON (see

Figure 1)

USB Port

Ethernet Port

Power ON/OFF Switch

AC Power Adapter

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Sin comentarios

Radlink CR Pro Guía de instalación Pagina 10